It’s
been a busy month – and it’s not over yet! I’ve been up to my ears in Christmas
shows. In fact my next show starts later tonight at 6pm. I’ve got everything
packed ready and soon I’ll have to leave to set up my stand. But since I’ve got
a few minutes to spare before I go, I thought I’d quickly blog about my extra
special news…
As
you can see in the photo above, I’ve had a lovely new kiln delivered! It
actually arrived weeks ago – at the beginning of November – but I’ve had so
much to organise with all the shows I’ve been doing I haven’t had any time to
blog it or even unwrap it properly. I’ve been walking past it in the studio
carrying boxes of pots backwards and forwards, but I haven’t had any time to
play around with it. Most frustrating!
It’s
a toploading electric kiln, single phase, 40 amp and as you can see from the
photo, bright green! It still needs to be wired directly into the plug, which
means I have to wait a bit longer… And it’s actually bigger than I expected.
When it was being unloaded off the back of the lorry there was a moment when I
thought it wasn’t going to fit through the front door. And when we got it off
the pallet and to the bottom of the front steps, then it really became obvious it
wasn’t going to fit through the front door. Not only was it impossibly heavy
for two people to lift (there was nothing to hold onto and frankly the steps
defeated us) but also, despite all my careful measurements, I hadn’t accounted
for the door handle…there’s a lesson there.
However,
we managed eventually to wheel it into the studio via a long circumambulatory
route (luckily it was already fitted with casters) and we even had daylight to
spare! We pushed it into the corner of the studio and went into town to
celebrate with a couple of well-deserved lattes. And since then my poor new
kiln has been sitting waiting exactly where we left it.
Anyway,
I have to go now to set up a show! Hopefully next month the kiln will be
plugged in and ready to go.
